how can we call a scope to workspace witout opening the model file?

in my project, i ve designed an active power filter using model file. In that for optimization of parameters, i ve used an algorithm. This model file is being called to the m-file(algorithm). Here i need a suggestion to compile the algorithm without opening the model file (i.e.,) only the scope should be viewed. with regards, shanthi.

Answer 1

[Roshin Kadanna Pally]

You can save your model with Scopes closed. Then do the following:

load_system('modelName');

open_system('modelName/scopeName');

To compile the model (I assume this will also compile your algorithm):

set_param('modelName', 'SimulationCommand', 'Update');

This will not send data to the Scope. To view data on Scope, simulate the model using sim command. The model remains closed.

Answer 2

[Andreas Goser]

In my view, you can run the simulation with the SIM command, but not open the scope. However, you can use the simulation data to plot the result in a MATLAB figure, that looks pretty much the same (compared to the scope).