Arduino Due Simulink build error

Hello,

i have a problem to run a simulink model on an Arduino Due Board. As a first test, i only want a blinking led. I have installed the Arduino Hardware Support Package for Matlab and Simulink. But when i want to compile my model, i got the error message "Faild to generate all binary outputs". When i do the same for an Arduino Uno Board it runs fine. Do i have to do some special configurations für the Arduino Due? The Board Type under Tools-->RunOnTargetHardware i have changed. I'm using Matlab 2015b

kind regards Tobias

[Madhu Govindarajan]

http://www.mathworks.com/matlabcentral/answers/156208-how-do-i-fix-failed-to-generate-all-binary-outputs-error - From this post it looks like the support package did not install correctly. Could you try reinstalling the support package?

[Tobias]

Thanks for the tip, but thats not the problem. The support package ist correct installd. I have it also tested on three different systems with every time the same error.

[Madhu Govindarajan]

Have you contacted Technical Support with the MathWorks? It could be a bug and they can let you know if there are any known fixes.

[Walter Roberson]

Note for Due "DAC and CAN channels not currently supported." . If I recall correctly, some of the earlier releases were even more restricted for Due.

Answer 1

[mohammad amin rostami]

i'v got this problem to

[Tobias]

I had contacted the Matlab Support. It was a bug in the version of the Support-Package i used. I think in later versions the bug were fixed. Maybe an update can fix your problem.