i dont understand the error here, where do i put the parantheses??
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
% The command below loads the following variables:
% y: vector of output data
% t: vector of corresponding times
% yss: steady-state output
load variables.mat
S=stepinfo(y,t,yss)
% Estimate the parameters of the underdamped, second-order system:
zeta = (-log(S.Overshoot/100))/((pi^2 +(log(S.Overshoot/100)) ^2) ^0.5) % damping ratio
wn = pi/((S.PeakTime)(1-(zeta)^2)^ 0.5) % natural frequency (in rad/sec)
K = yss(wn)^2 % gain
0 Kommentare
Antworten (1)
the cyclist
am 30 Nov. 2022
It looks like on this line of your code:
wn = pi/((S.PeakTime)(1-(zeta)^2)^ 0.5)
you are assuming that MATLAB will understand that
(a)(b)
means you should mutliply a and b, but that is not valid MATLAB syntax. Perhaps you meant
wn = pi/((S.PeakTime).*(1-(zeta)^2)^ 0.5)
?
Siehe auch
Kategorien
Mehr zu Legend finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!