Filter löschen
Filter löschen

Issue with figure display

7 Ansichten (letzte 30 Tage)
Turbulence Analysis
Turbulence Analysis am 10 Mär. 2022
Hi,
I have used below command inside the for loop to avoid the display of figures. However, if I run some other command even in new editor page there is no figure display at all. And also, the new figures are always overlapping with the previous ones..
This problem is getting rectified only if I restart the Matlab..
I seriuosly don't know what's happening with this command,, Any help please ??
set(0,'DefaultFigureVisible','off')

Akzeptierte Antwort

Rik
Rik am 10 Mär. 2022
The command you posted will set the default visibility property to off. That means that a new figure that is created will have its visibility turned off. This setting affects every figure creation in Matlab.
You should change the code in your loop to create the figures with their visibility off instead.
If that is not possible, you should restore the default when you're done.
DefaultFigureVisible=get(0,'DefaultFigureVisible');
set(0,'DefaultFigureVisible','off')
% rest of your code
set(0,'DefaultFigureVisible',DefaultFigureVisible)
  8 Kommentare
Rik
Rik am 10 Mär. 2022
That is what I suggested as well (as the preferred solution actually): if create new figures in your loop, you should set the Visible property then.
for n=1:10
f(n)=figure('Visible','off');
ax=axes('Parent',f(n));
plot(rand(10,1),'Parent',ax)
title(sprintf('n=%d',n))
end
set(f(randi(end)),'Visible','on')
Turbulence Analysis
Turbulence Analysis am 10 Mär. 2022
Sure.. Thanks

Melden Sie sich an, um zu kommentieren.

Weitere Antworten (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by