can i run and directly modify a simulink model on a beaglebone black that is connected via wifi?

I have the model in simulink and also I have configured the wifi adapter (in this case I use the interface that has the BEAGLEBONE board for setup ip fo the communication). It is possible that I can run the model simulik directly from matlab without having to intervene in linux interface, ie, if I change a value to model simulink real time, BEAGLEBONE board recive the data and runs it, for example, ordered to move an actuator?

Answer 1

[Hong Ye]

it is possible to run the model in external mode and tune the parameter (assume it is tunable in your Simulink model) at run-time.

Answer 2

[Murat Belge]

Assuming you have installed the Embedded Coder Support Package for BeagleBone Black hardware, yes. Simulink requires a TCP/IP connection to run a model on BeagleBone Black hardware. Wired or wireless does not make a difference.