Filter löschen
Filter löschen

How to model a reference signal in RF of radar system?

1 Ansicht (letzte 30 Tage)
Chen
Chen am 24 Jun. 2014
Beantwortet: Chen am 26 Jun. 2014
On page 8 of Dr. Giorgia Zucchelli's "Design and Verify RF Transceivers for Radar Systems" webinar, there are LO1 and LO2. Can someone let me know how to use RF toolbox and SimRF to model a 10 MHz synreference signal that is connected these LOs?

Antworten (2)

Giorgia Zucchelli
Giorgia Zucchelli am 24 Jun. 2014
Dear Chen,
in SimRF you have two modelling technologies: Equivalent Baseband and Circuit Envelope. Both technologies are suitable for modelling super-etherodyne systems.
With Equivalent Baseband the LO signal is "embedded" in the model of the mixer that performs a down- or an up- conversion. The model assumes the LO to be a sinusoidal tone. It is not possible to specify arbitrary LO signals but it is possible to specify the phase noise spectral mask of the LO tone.
With Circuit Envelope you can specify arbitrary LO signals, these can be generated with Circuit Envelope signal sources (such as sinusoidal sources), or can be generated in Simulink and then connected to the LO port of the Circuit Envelope Mixer using an input port as a gateway between the two simulation domains. The Simulink signal will represent the envelope (modulation) of the LO signal centred around the carrier frequency specified by the input port.
The webinar "Design and Verify RF Transceivers for wireless communications systems" provides some more insights and examples:
I hope that this helps, with best regards, Giorgia

Chen
Chen am 26 Jun. 2014
Many thanks Giorgia I will visit the link and get back to soon. Chen

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by