Use Message Reception Callback Functions in CAN Communication
This example shows you how to use a callback function to process messages received from a CAN channel. It uses MathWorks® virtual CAN channels connected in a loopback configuration. This example describes the workflow for a CAN network, but the concept demonstrated also applies to a CAN FD network.
Create a Receiving Channel
Create a CAN channel using
canChannel to receive messages by specifying the vendor name, device name, and device channel index.
rxCh = canChannel("MathWorks", "Virtual 1", 2)
rxCh = Channel with properties: Device Information DeviceVendor: 'MathWorks' Device: 'Virtual 1' DeviceChannelIndex: 2 DeviceSerialNumber: 0 ProtocolMode: 'CAN' Status Information Running: 0 MessagesAvailable: 0 MessagesReceived: 0 MessagesTransmitted: 0 InitializationAccess: 1 InitialTimestamp: [0×0 datetime] FilterHistory: 'Standard ID Filter: Allow All | Extended ID Filter: Allow All' Channel Information BusStatus: 'N/A' SilentMode: 0 TransceiverName: 'N/A' TransceiverState: 'N/A' ReceiveErrorCount: 0 TransmitErrorCount: 0 BusSpeed: 500000 SJW:  TSEG1:  TSEG2:  NumOfSamples:  Other Information Database:  UserData: 
Configure the Callback Function
Set the callback function to run when a required number of messages are available on the channel.
rxCh.MessageReceivedFcn = @receivingFcn;
Configure the Message Received Count
Specify the number of messages required in the channel before the callback function is triggered.
rxCh.MessageReceivedFcnCount = 30;
Implement the Callback Function
The example callback function receives all available messages from the channel and plots the CAN identifiers against their timestamps on each execution.
function receivingFcn(rxCh) % RECEIVINGFCN A CAN channel message receive callback function. % % This is a callback function used to receive CAN message. It receives % messages from the channel RXCH and plots the result. % % Copyright 2009-2016 The MathWorks, Inc. % Receive all available messages. rxMsg = receive(rxCh, Inf, 'OutputFormat', 'timetable'); % Plot the signal values against their message timestamps. plot(rxMsg.Time, rxMsg.ID, 'x'); ylim([0 2047]) xlabel('Timestamp'); ylabel('CAN Identifier'); hold all; end
Start the Channel
start command to set the channel online.
Execute the Callback Function
generateMsgs creates CAN messages and transmits them at various periodic rates to create traffic on the CAN bus. As the messages are transmitted, the callback function executes each time the threshold specified by property
MessageReceivedFcnCount is met.
Inspect the Remaining Messages
MessagesAvailable property of the channel to see the number of remaining messages. Since the available message count is below the specified threshold, more messages are required to trigger the callback another time.
ans = 11
Stop the Channel
stop command to set the channel offline.