This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English version of the page.

Note: This page has been translated by MathWorks. Click here to see
To view all translated materials including this page, select Country from the country navigator on the bottom of this page.

Setup and Configuration

Install the hardware support for Xilinx® Zynq® Platform.

The embedded target for Xilinx Zynq Platform enables you to:

  • Build a Simulink model that loads and runs an executable on the ARM® Cortex®-A processor embedded in the Xilinx Zynq Platform.

  • Use the capabilities and features described in Supported Features for Xilinx Zynq Platform

To get this embedded target, perform the steps described in Install Support for Xilinx Zynq Platform.

Functions

zynqDisplay most recent IP address, user name, and password

Topics

Supported Features for Xilinx Zynq Platform

List of supported Features for Xilinx Zynq Platform

Install Support for Xilinx Zynq Platform

Instructions to install support for Xilinx Zynq platform.

Getting Started with VxWorks 7 on Xilinx Zynq Platform

This example shows you how to configure the VxWorks® 7 operating system, generate code from a Simulink® model and run the executable on the Zynq hardware.

Getting Started with Embedded Coder Support Package for Xilinx Zynq Platform

This example shows you how to generate code from a Simulink® model and run the executable on the Zynq hardware.

TFTP/WFTPD Configuration Guide

Setup and configure Trivial File Transfer Protocol (TFTP) or Winsock File Transfer Protocol Daemon (WFTPD) to use with your hardware board

Hardware Setup Verification

Description of how the Embedded Coder® Support Package for Xilinx Zynq Platform verifies the setup of the Xilinx Zynq hardware board.

Troubleshooting

Troubleshooting Xilinx Zynq Platform and Development Computer Connection

To check if the Xilinx Zynq platform is properly configured, repeat the steps in TFTP/WFTPD Configuration Guide.

Configure Network Interface Card (NIC) on Development Computer

Configure a Network Interface Card (NIC) on development computer to connect to hardware board

Get IP Address of Xilinx Zynq Platform

You can get the IP address of the Xilinx Zynq platform from the MATLAB® Command Window or using the Linux® command line.

Command Line Session with Xilinx Zynq Platform

Open a serial command-line session with Xilinx Zynq platform.

Sending PING Request to Xilinx Zynq Platform

Process to PING an Xilinx Zynq platform connected to your development computer