Model Configuration Parameters for ARM Cortex-R Processors

Hardware Implementation Pane Overview

Configure hardware board to run Simulink^® models.

1. In the Simulink Editor, select Simulation > Model Configuration Parameters.

2. In the Configuration Parameter dialog box, click Hardware Implementation.

3. Set the Hardware board parameter to TI Hercules RM57Lx Launchpad.

4. The parameter values under Hardware board settings are automatically populated to their default values.

   You can optionally adjust these parameters for your particular use case.

5. Click Apply to apply the changes.

For more information on selecting a hardware support package and general configuration settings, see Hardware Implementation Pane (Simulink).

Operating system options

Parameter	Description	Default Value
Base Rate Task Priority	Sets the static priority of the base rate task in the operating system.	14

Build Options

Parameter	Description	Default Value
Build action	Defines how Embedded Coder® responds when you build your model.	Build, load, and run
Flash erase options	Defines how Embedded Coder writes the new build to the flash memory.	Entire Flash

Clocking

Parameter	Description	Default Value
CPU Clock Frequency (MHz)	The CPU clock (GCLK1) frequency in MHz.	300
System Clock Frequency (MHz)	The System Clock (HCLK) frequency in MHz.	150
Primary Peripheral Clock (MHz)	The peripheral clock (VCLK) frequency in MHz.	75

Serial Connectivity

Parameter	Description	Default Value
Serial port	Serial port on the hardware board.	COM1
Baud rate	Set the baud rate of the serial port on the hardware.	115200

External Mode

Parameter	Description	Default Value
Communication interface	Transport layer used to exchange data between host computer and hardware.	Serial
Serial port	Serial port on the hardware board.	COM1
Baud rate	Set the baud rate of the serial port on the hardware.	115200
Wait for a start packet from the host before execution	Wait for a start packet from the host before execution.	Enabled