To create a Digital Write block that writes the value of GPIO
pins when deployed to an Arduino® hardware board, complete these
Create a Project Folder
Write the Hardware-Specific C/C++ Code
Select a System Object Template
Specify the Initialization, Output, and Termination Behavior
Test System Object on MATLAB Command Line
Create the MATLAB System Block
Generate Code and Deploy the Model to the Hardware
Block Mask | Create a Digital Read Block | Sharing Device Driver Blocks with Other Users | Simulation with Device Driver Blocks
You clicked a link that corresponds to this MATLAB command:
Run the command by entering it in the MATLAB Command Window.
Web browsers do not support MATLAB commands.
Choose a web site to get translated content where available and see local events and offers. Based on your location, we recommend that you select: .
You can also select a web site from the following list:
Select the China site (in Chinese or English) for best site performance. Other MathWorks country sites are not optimized for visits from your location.
Contact your local office