Main Content

PWM Control of a Boost Converter

This example shows you how to control a boost converter using the PWM block in Simulink. The boost converter is implemented using the Boost Converter (Simscape Electrical) block in the Simscape™ Electrical™ library.

A PWM signal is used to control the switching device, or gate, of the boost converter. The command signal, or duty cycle, is generated from the PID controller to track the desired step-up voltage (Vref) of 18V

This is a relatively high frequency application; the switching gate operates at around 200kHz. Therefore, a pulse period of 1/200,000 or 5e-6s is chosen for the PWM signal.

Given the small time steps, the boostconverter_pwm model provided with the example is loaded from a steady state at 0.069s.

A visualization of the boost converter operation around the 0.1s mark is shown below.

For alternate physical modeling implementations of PWM control, see Pulse Width Modulation (Simscape Electrical).

See Also

|

Related Examples

More About