NA-MAAB — a, b
JMAAB — a, b
All
The Lookup Table Dynamic block
parameter Lookup Method shall be set to
Interpolation – Use End Values
.
Not Applicable
These n-D Lookup Table block parameters shall be set as follows:
Set Interpolation Method to Linear
point-slope
or Linear Lagrange
.
Set Extrapolation Method to
Clip
.
Select Use last table value for inputs at or above last breakpoint.
Not Applicable
Sub IDs a, b:
When an unexpected value is entered for the Lookup Table block, the output is determined by using the extrapolation method and can become an impossible value or cause the Lookup Table output to overflow.
Model Advisor check: Check usage of Lookup Tables (Simulink Check)
R2020a
JMAAB guideline jc_0626, which is available in Control Algorithm Modeling Guidelines Using MATLAB, Simulink, and Stateflow on the MathWorks® website.