Linear variable resistor in electrical systems
The Variable Resistor block models a linear variable resistor, described with the following equation:
|Resistance, i.e., the value presented at the control port|
Connections + and – are conserving electrical ports corresponding to the positive and negative terminals of the resistor, respectively. P is a physical signal input port that controls the resistance value. The current is positive if it flows from positive to negative, and the voltage across the resistor is equal to the difference between the voltage at the positive and the negative terminal, V(+) – V(–).
The minimum resistance value. If the input signal falls below
this level (for example, turns negative), this minimum resistance
value is used. The parameter value must be nonnegative. The default
Use the Variables tab to set the priority and initial target values for the block variables prior to simulation. For more information, see Set Priority and Initial Target for Block Variables.
The block has the following ports:
Electrical conserving port associated with the resistor positive terminal.
Electrical conserving port associated with the resistor negative terminal.
Physical signal input port that provides the resistance value.